(A/B) 35W HID Dead lamp x 2(C) 2 Ballast (D) 12 fixing buckles of wiring harness (E) 2 brackets of ballast (F) 14 sets of bolts, nuts and gaskets (G) 1 set of wire splice to power supply.

2 PROCESS OF INSTALLATION

(1) Please open the hood and take off the assembly of headlights on the two sides (left and right). In the case of enough room for installation, the headlights may not be taken down.

(2) Open up the back cap of the assembly of headlights and take out the original bulb.

(3) Drill a hole in the middle of the back cap with a 25mm cutter.

(4) Take down the plastic cover/shield surrounding the HID head lamp.

(5) Put the HID head lamp into the headlights.

(6) The installation diagram o power supply and relevant data are as follows.




*Please use a fuse of 20A (fuses of 20A below will melt in turning on the lamp.)