*Please read first the foundation install the catalogue.
*Before installing far near light system, please the first careful check power supply on-line and plus or minus pole, adjust input the exportation lead the linear position, then according to top the diagram shows the beginning gearing.
*Do not make an effort the ambulation parts that push pull the lamp bulb, will result in the lamp bulb damage.

(7) First plug the bulb¡¯s wiring harness into the rubber base, and then put into the back cap of assembly. After that, please shut the headlight shield tightly.

*Installation method of power supply's port*
1) Insert wiring harness into Ballast¡¯s interior slot.
2) Connect ballast¡¯s red wire with the red wire of bulb (+), and do the same thing to the black wires (-).
3) Press the rubber end into cover the metal end.

(8) Fix Ballast on any solid place in the engine room by using double-sided tape, fixing buckles and brackets (attention: avoid high temperature).

* Please refer to the instructional drawing on the left in running the relay*
1) Drill a hole with a 25mm cutter and a 8mm drill in the middle on the back cap of the headlight.
2) As shown in the drawing, first insert the wire of relay and then put the rubber base into the hole of 8mm on the back cap of the headlight.

(9) Connect the Ballast wiring harness to the wiring harness of the bulb.

(10) Inspect whether the two headlights are in normal operation state.
*If the two lights are extinct or glimmer simultaneously, please change with the above 70A batteries. The said problem may be caused by shortage of electric power supply.