Angel Eyes Installation Instruction| FAQ| Support| Tenole International Company Limited-Guangzhou City Tenole Electronic Technology Co.,ltd

Step 1:Check the vehicle if need to release the bumper first then be able to take the headlight assembly out.

Step 2: Release the screws that fix the assembly on the vehicle then take it out.

Step 3: Remove the clips that hold the front and back part of the assembly.

Step 4:Check the backside of the assembly. There may be some of the screws need to be removed.

Step 5: Check the assembly if its front and back housing is attached with sealant, if not sealed.then you can take the assembly apart after removing the clips and screws.(skip to step 10) if there is sealant applied, you must go over the step 6-9.

Step 6: Pry the plastic clips and heat blow with a hair dryer,Pre-open these clips will help the later opening faster and easier.

Step 7: This step is to soften the sealant.if you have a big oven available to bake the assembly, pre-heat the oven to 80 centigrade and keep constantly this temperature,put the assembly in, bake for 15 minutes.Note, take off all the bulbs(high/low beam.parking light and turn signals etc.) before put the assembly into the oven.

If you do not have oven, then you can use hear-gun or hair dryer blowing along the sem to soften the sealant. With this method,you may need an assistant to help with the blowing.

Step 8: When the sealant is fully softened,keep blowing and pry from the angle of assembly, and pull them apart with fingers.

Step 9: Once the angle is opened,blowing along the seams,gently separate the assembly.

Step 10: The angel eyes kit is mostly installed on the chrome trim/reflector.Some of the vehicles the chrome trim/reflector is fixed with the front clear cover, you may need to release clips or screws to take it out.

Step 11: Prepare the angel eyes rings.According to the characters of every headlamp, there are some methods of ring fixation.It may use 3M double side sticker or adhesive glue.

Step 12: Fit the ring to chrome trim/ reflector. Some of the rings must be inserted from the front side,then slightly move the ring until you get the best position for it.

Some of the ring must fit it from back side.

Connect the angel eyes to the side lights(daytime lights). Remove your side light bulbs so when the side lights are turned on the rings will glow.

Home > FAQ